The Bullseye cleaning tile cleaning process.
Before any cleaning starts, we assess every workspace and protect any areas where water or cleaning solution could cause damage.
- Pretreatment - First, we pre-spray tile and grout cleaner depending on soiling content. Dwell time (the amount of time the solution is left on the floor) is dependent on specific cleaner we are using.
- Agitation - We have an assortment of orbital floor machines with a variety of brushes to scrub the tile and grout. Each brush and scrub mount has a specific purpose to clean depending on the type of tile and soil content. A hand edging tool is used for tight corners or hard to reach areas.
- Rinse - Bullseye uses a Hydro-force SX 15 that is used for rinse and extraction of dirt and grime. The equipment works in conjunction with our current truck mount system that delivers 200-degree hot water to pressure wash the dirt and grime out of the tile and grout and simultaneously vacuum and extract the dirty water back to the waste tank in the van. The vacuum pulls almost all the water off the floor leaving the floor to dry in just a few minutes.